=====================  Product Identification  =====================

Product ID:KEL-SEAL TERPOLYMER COATING 1128 SERIES
MSDS Date:05/03/1990
FSC:8010
NIIN:00N011996
MSDS Number: BQNYM
=== Responsible Party ===
Company Name:KELLY-MOORE PAINT CO,INC
Address:1015 COMMERCIAL ST
City:SAN CARLOS
State:CA
ZIP:94070
Country:US
Info Phone Num:415-592-8337
Emergency Phone Num:800-424-9300 (CHEMTREC)
Preparer's Name:JULIAN E SCHAFER
CAGE:23865
=== Contractor Identification ===
Company Name:KELLY-MOORE PAINT CO INC
Address:1015 COMMERCIAL ST
Box:City:SAN CARLOS
State:CA
ZIP:94070
Country:US
Phone:415-592-8337
CAGE:23865

=============  Composition/Information on Ingredients  =============

Ingred Name:ETHYLENE GLYCOL.VAPOR PRESSURE:0.1 MMHG.
CAS:107-21-1
RTECS #:KW2975000
Fraction by Wt: <5%
Other REC Limits:N/K 
OSHA PEL:50 PPM C
ACGIH TLV:50 PPM C VAP & MIST
EPA Rpt Qty:1 LB
DOT Rpt Qty:1 LB

Ingred Name:PHENYLMERCURIC ACETATE.PAINT PRESERVATIVE TO CONTROL
    MICROORGANISMS.OSHA PEL & ACGIH TLV FOR ARYL & INORG MERCURY CMPDS.
CAS:62-38-4
RTECS #:OV6475000
Other REC Limits:N/K 
OSHA PEL:0.1 MG(HG)/M3 SKIN
ACGIH TLV:0.1 MG(HG)/M3 SKIN
EPA Rpt Qty:100 LBS
DOT Rpt Qty:100 LBS

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:N/K 
Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:CHRONIC:NONE KNOWN.
Explanation of Carcinogenicity:NONE
Effects of Overexposure:EYES/SKIN:IRRITATION.INGESTION:NAUSEA,
    DIZZINESS,HEADACHE,CONFUSION,UNCONSCIOUSNESS.INHALATION:NAUSEA,DIZZ
    INESS, HEADACHE,CONFUSION,IRRITATION TO UPPER RESPIRATORY
    TRACT,UNCONSCIOUSNESS.
Medical Cond Aggravated by Exposure:SEE YOUR PHYSICIAN FOR SPECIFIC
    MEDICAL OPINION REGARDING YOUR CONDITION.

=======================  First Aid Measures  =======================

First Aid:EYES:FLUSH WITH LARGE VOLUMES OF WATER FOR AT LEAST 15
    MINUTES.GET MEDICAL ATTENTION.SKIN:WIPE OFF WITH A RAG.WASH
    THOROUGHLY WITH SOAP AND WATER.INGESTION:CONSULT HOSPITAL EMERGENCY
    ROOM OR POISON CO NTROL CENTER IMMEDIATELY.INHALATION:REMOVE TO
    FRESH AIR.RESTORE BREATHING.CONSULT PHYSICIAN.

=====================  Fire Fighting Measures  =====================

Flash Point:>200F,93.33C
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA AND FULL
    PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:CLSD CONTR MAY EXPLODE (DUE TO BUILDUP OF
    STEAM PRESS) WHEN EXPOSED TO EXTREME HEAT.HAZ DECOMP PROD:MAY
    PRODUCE HAZ FUMES WHEN HEATED TO DECOMP AS IN WELDING.

==================  Accidental Release Measures  ==================

Spill Release Procedures:VENTILATE AREA TO PREVENT BUILD-UP OF
    VAPORS.FOR SMALL SPILLS,SOAK UP WITH ABSORBENT.FOR LARGER
    SPILLS,DIKE AREA WITH ABSORBENT MATERIAL AND SCOOP UP LIQUIDS.
Neutralizing Agent:N/K 

======================	Handling and Storage  ======================

Handling and Storage Precautions:STORE UPRIGHT IN SEALED CONTAINERS
    AWAY FROM HEAT AND FLAME.
Other Precautions:REMOVE AND WASH CONTAMINATED CLOTHING BEFORE REUSE.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:USE PARTICLE MASK TO AVOID BREATHING SPRAY MIST/
    SANDING DUST IF LOCAL VENT IS ADEQUATE TO KEEP TLV WITHIN
    ACCEPTABLE LIMITS.IF LOCAL VENT IS NOT ADEQUATE,THE USE OF AN
    APPRVD RESPIRATOR FOR ORGANIC V APOR,SUPPLIED AIR/SCBA IS
    RECOMMENDED.
Ventilation:LOCAL EXHAUST SUFFICIENT TO KEEP TLV BELOW PRESCRIBED
    LIMITS.
Protective Gloves:REC IF NEC TO PVNT EXTENDED EXPOSURE.
Eye Protection:GLASSES W/ SIDE SHIELDS/GOGG (SEE SUP)
Other Protective Equipment:N/K 
Work Hygienic Practices:REMOVE AND WASH CONTAMINATED CLOTHING BEFORE
    REUSE.
Supplemental Safety and Health
PRODUCT CONTAINS PIGMENTS (TITANIUM DIOXIDE, SILICATES,SILICON DIOXIDE)
    THAT MAY BE DUST HAZARDS IN THEIR ORIGINAL DRY POWDER FORM BUT ARE
    NOT HAZARDOUS IN WET PAINT.BP:212F,(H2O)100C.SPEC GRAV:1.08-1
    .32,H2O=1.RTE OF ENTRY:SKIN/EYE CONTACT(MFR).EYE PROT:ARE REC TO
    PVNT EYE CONTACT.

==================  Physical/Chemical Properties  ==================

HCC:N1
Boiling Pt:B.P. Text:SEE SUPP
Melt/Freeze Pt:M.P/F.P Text:N/K 
Decomp Temp:Decomp Text:N/K 
Vapor Pres:N/K 
Vapor Density:<1 (AIR=1)
Spec Gravity:SEE SUPP
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:N/K 
Appearance and Odor:N/K 
Percent Volatiles by Volume:45-55

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Hazardous Decomposition Products:MAY PRODUCE HAZARDOUS FUMES WHEN
    HEATED TO DECOMPOSITION AS IN WELDING.

====================  Disposal Considerations  ====================

Waste Disposal Methods:DISPOSAL MUST BE IN ACCORDANCE WITH
    FEDERAL,STATE AND LOCAL REGULATIONS .DISCARD IN LAND FILL IN SEALED
    METAL CONTAINERS AWAY FROM HEAT AND FLAME IN ACCORDANCE WITH
    REGULATIONS.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.